Tesla to provisionally shutter Buffalo PV factory amid COVID-19 concerns

Facebook
Twitter
LinkedIn
Reddit
Email
Image credit: Tesla

Silicon Valley giant Tesla has decided to temporarily close down factories in two US states after coming under fire over the exposure of its staff to the COVID-19 pandemic.

The firm will “temporarily suspend” production at its Gigafactory 2 solar cell and module plant in Buffalo (New York) and its electric vehicle facility in Fremont (California) over the next few days, according to a statement released by the company this week.

This article requires Premium SubscriptionBasic (FREE) Subscription

Try Premium for just $1

  • Full premium access for the first month at only $1
  • Converts to an annual rate after 30 days unless cancelled
  • Cancel anytime during the trial period

Premium Benefits

  • Expert industry analysis and interviews
  • Digital access to PV Tech Power journal
  • Exclusive event discounts

Or get the full Premium subscription right away

Or continue reading this article for free

The provisional shutdowns will not be complete at either location, the statement suggests. Buffalo will remain operational “for those parts and supplies necessary for service, infrastructure and critical supply chains” while Fremont will retain certain “basic operations”.

“Despite taking all known health precautions, continued operations in certain locations has caused challenges for our employees, their families and our suppliers,” Tesla’s statement reads, adding that the move to retain partial operations “honours” the directions from the US federal government.

Tesla’s decision to stop production in New York and California – where its motor- and battery-making plant in Nevada will stick to business as usual for now – follows a controversy over its response to COVID-19 in California, so far amongst the US states most affected by the pandemic.

In recent days, US outlets had documented the widespread criticisms over Fremont’s continued operations despite the ‘shelter in place’ orders issued by county authorities. Tesla CEO Elon Musk’s Twitter remarks that “the panic will cause more harm than the virus” had stoked the controversy.

COVID-19 another setback after Panasonic’s Gigafactory 2 exit

The pandemic-driven winddown represents yet another setback for Tesla’s Gigafactory 2 plant, which it had scooped up through the SolarCity takeover in 2016. The project’s key partner, Japanese electronics giant Panasonic, decided last month to pull out from the venture.

The firm recently sought to spread good news about the Buffalo plant; last Sunday, it took to Twitter to report the factory had built 4MW of solar roofs in a week, “enough for up to 1000 [sic] homes”. Last month, it had emerged Panasonic staff at the plant will be assisted by the state to find new jobs.

In its first few months of existence, the escalating COVID-19 emergency has already had several ramifications for Tesla. A high-profile trial over its US$2.6 billion acquisition of SolarCity in 2016 was meant to continue this week but has been postponed, with no new dates yet within sight.

Contacted by PV Tech this week, a spokesperson from the Delaware Court of Chancery confirmed COVID-19 concerns were behind its decision to delay the trial pitting Musk and others at Tesla against a group of shareholders, who allege they were misled over SolarCity’s financial state.

The threat of litigation has coincided with a tanking of Tesla’s solar installations between 2017 (522MW), 2018 (326MW) and 2019 (173MW). The drop has seen the firm give up its spot as the top US residential solar installer, falling behind a bullish Sunrun.

In its statement this week, Tesla explained it held US$6.3 billion in cash at the end of Q4 2019, followed by its recent US$2.3 billion raise. “We believe this level of liquidity is sufficient to successfully navigate an extended period of uncertainty,” the firm said.

PV Tech has set up a tracker to map out how the COVID-19 pandemic is disrupting solar supply chains worldwide. You can read the latest updates here.

The prospects and challenges of solar's new era in the US will take centre stage at Large Scale Solar USA 2020 (Austin, Texas, on 23-24 June 2020)

13 October 2026
San Francisco Bay Area, USA
PV Tech has been running an annual PV CellTech Conference since 2016. PV CellTech USA, on 13-14 October 2026 is our fourth PV CellTech conference dedicated to solar manufacturing in the USA. From polysilicon, wafers, ingots, cells and modules, to critical component suppliers including glass and frames, the event connects every stage of the value chain under one roof. PV CellTech USA also brings together investors, innovators, manufacturers and industry stakeholders to collaborate and strengthen domestic solar manufacturing across the United States.

Read Next

July 10, 2026
The so-called “One, Big, Beautiful Bill” Act (OBBBA) has cost the US US$68.2 billion in capital investments into clean energy projects, according to analysis from business advocacy group E2.
July 10, 2026
Intertek CEA explores how companies have to navigate US solar PV procurement contracts amidst tariffs and customs risks.
July 8, 2026
Leeward Renewable Energy (LRE) has brought 525MW of solar capacity online in Oklahoma, with a further 200MW under construction.
July 7, 2026
US solar cell manufacturer ES Foundry has completed the expansion of a 2GW solar cell production line at its Greenwood, South Carolina facility.
July 7, 2026
Multinational solar manufacturer Canadian Solar has appointed a new CEO at its solar and energy storage project development subsidiary, Recurrent Energy.
July 6, 2026
Spanish renewables developer Acciona Energía will build a 235MWp solar PV project in the US state of Kentucky, its 18th renewable energy project in the country.

Upcoming Events

Solar Media Events
October 13, 2026
San Francisco Bay Area, USA
Solar Media Events
November 3, 2026
Málaga, Spain
Solar Media Events
November 24, 2026
Warsaw, Poland
Solar Media Events
April 20, 2027
Istanbul, Türkiye