The FUD (fear, uncertainty and doubt) over the solar industry entering it second major overcapacity cycle is being replaced by a focus on how much overcapacity verses end market demand exists, especially in 2017 and therefore how low will PV module ASP’s go?
Hong Kong-headquartered Asia Clean Capital and the US’ Ten K Solar have signed an exclusive China partnership to develop an anticipated 40MW worth of solar projects within the next 18 months.
Tech conglomerate Apple has committed to go 100% renewable with its international operations as part of joining the global renewable energy initiative RE100.
High-efficiency PV module producer and project developer SunPower is to take over its joint venture (JV) solar cell manufacturing operations in Malaysia from Taiwan-based partner AUO, a subsidiary of AU Optronics Corporation at a cost of US$170 million, payable over the next four years.
Fraunhofer ISE said it was spearheading the largest research project (APV-Resola) in Germany to establish whether the dual use of land for the production of electricity using photovoltaic (PV) modules can be commercially viable with a range of crops grown on the same land.
The US has once again come out on top after the World Trade Organisation (WTO) rejected a challenge by India in favour of its domestic content requirements (DCR).
According to Bloomberg New Energy Finance (BNEF) US residential solar installations are expected to increase by 21% in 2016, yet growth in 2017 is expected to be a tepid 0.3%.
The University of Delaware’s Institute of Energy Conversion (IEC) has been awarded US$2.1 million from the SunShot Initiative for two research projects aiming to improve the performance of interdigitated back contact (IBC) solar cells while reducing their production costs and new techniques for CIGS deposition.
The 33rd European Photovoltaic Solar Energy Conference and Exhibition (EU PVSEC) has turned away from co-locating with Intersolar Europe in June, 2016 and has returned to a September 2017 slot and be held in Amsterdam.
Solar panel manufacturers that fail to keep up with emerging technology trends will be under tremendous pressure in 2017, according to host of their peers at SPI 2016.
